Alltek SprayPlast (Tyrex)

Typical Spreadability

0.5 to 0.6 kg/m² per layer depending on smoothness of substrate.

Density

1.6 +/- 0,1 kg/l

Solid Content

• Solid content by mass: 66%
• Solid content by volume: 44%

Application conditions

• +8°C to +35°C
• Max. relative humidity 70%

pH

8 +/- 1

Cleaning tools

With water

Drying

• 3 h on average, depending on application thickness, temperature, ventilation, humidity and substrate type.

Recommended thicknesses

• Min. thickness: 0,3 mm
• Max. thickness: 0,4 mm

• Ease of use for very significantly higher application speed.
• Excellent adhesive properties (IREF test report no. 08/2-104-L20).
• Fire rating: A2-s1, d0 as per European standard EN 13501-1.
• Classification: group III class 2 as per AFNOR NF T 36-005, in compliance with the standard AFNOR NF T 30-608

• Returnable, stackable 112 l plastic drum with protective cover.
• Shelf life is 9 months in unopened original packaging, protected from frost and extreme heat.

• VOC content: < 8 g/l.

Substrates:

• Plasterboard.
• Finishing on filling plaster.

Preparation of substrate:

• The substrates, preparatory work and application conditions must be compliant with applicable building trade regulations (e.g. DTU) and standards.

Application tips:

• The surfaces must be perfectly finished, sanded.
• Stir before use if necessary.
• All airless pumps, flow rate > 5 L (do not use filter) for perfect spreading.
• Xtreme 60 pump system with 112 l drum (get our advice).
• Airless nozzles size 23 to 27, depending on equipment used (follow the manufacturer’s advice).
• Recommended pressure 220 bar, 3/8″ tube.
• Apply a single regular and uniform layer.

Recommendations:

• Ensure adequate ventilation to remove excess moisture and accelerate drying.