Alltek LM200 ROLLMAX

Typical Spreadability

1 liter/m² per mm of thickness.

Density

1,1 +/- 0,1 kg/l

Solid Content

• Solid content by mass : 61%
• Solid content by volume : 55%

Application conditions

• +8°C à +35°C
• Max. relative humidity  70% H.R

pH

8.5 +/- 1

Cleaning tools

With water

Drying

• 24 h on average, depending on application thickness, temperature, ventilation, humidity and substrate type. Sanding and recoating: after complete drying.

Recommended thicknesses

• Min. thickness : 0,5 mm
• Max. thickness : 4 mm

• Quick and easy roller application.
• Filling compound with low shrinkage.
• Ease of use: easy smoothing with excellent finish quality.
• Fire classification: A2-s1, d0 according to European standard EN 13501-1.
• Classification: family III class 2 according to AFNOR standard NF T 36-005, compliant with AFNOR standard NF EN 16566.

• 12-litre plastic bucket (ref. 103579).
• 17-litre plastic bucket (ref. 103580).
• Shelf life of 1 year in unopened original packaging, protected from frost and excessive heat.

• VOC content: < 1 g/l.
• Indoor Air Emission Class
  
• 

Supports :

• Concrete, brick, and terracotta tile, plaster, plaster block, plasterboard (drywall).
• For renovation: over fibreglass wall covering (glass fabric) or textured/structured coatings.
• Wood and wood-based panels (previously primed), and old paint coatings that are sound and well-adhered.

Preparation of substrate:

• The substrates, preparatory work, and application conditions must comply with the DTU and current standards.

Application tips:

• Mix/stir before use if necessary, and dip a black-fibre polyamide roller (180 to 300 mm) into the coating, then apply generously to the substrate.
• Smooth the coating using a flexible-blade spatula and, if necessary, sand after complete drying.
• Sanding with grit P220 to P240.

Recommendations :

• Ventilate the room during application and drying.
• Use clean, properly maintained PPE: gloves and eye protection designed against liquid splashes, and a mask during sanding operations.
• To clean tools, scrape off excess product and soak in a minimum amount of water.
• Do not dispose of residues down the drain. Dispose of contents/container at a hazardous or special waste collection facility.
• Store away from frost and heat.
• Reseal the container tightly after use.
• Ensure adequate ventilation to remove excess moisture and speed up drying.