ICP Alltek

  1. ICP Alltek
  2. Products
  3. Airless fillers
  4. Alltek SprayPlast

Alltek SprayPlast

Date de dernière modification

Airless primary plaster without smoothing

DESCRIPTION
Primary plaster applied without smoothing for thorough preparation of plasterboard. Alltek SprayPlast is intended to mask the shadows of jointing tapes and, due to its hardness, creates a high quality finish for partition walls and plasterboard ceilings. Alltek SprayPlast is white with a matt velvety finish.

USE
  • Primary interior plaster for walls and ceilings on plasterboard, exclusively for airless application.
  • Alltex SprayPlast spreads on application without skimming and can be top coated with all types of paint.
Typical spreadability 0.5 to 0.6 kg/m² per layer depending on smoothness of substrate.
Recommended thicknesses
  • Min. thickness: 0,3 mm
  • Max. thickness: 0,4 mm
Packaging 24kg (15L) plastic bucket

Détails

TECHNICAL SPECIFICATIONS

Typical Spreadability

0.5 to 0.6 kg/m² per layer depending on smoothness of substrate.

Density

1.6 +/- 0,1 kg/l

Solid Content

  • Solid content by mass: 66%
  • Solid content by volume: 44%

Application conditions

  • +8°C to +35°C
  • Max. relative humidity 70%

pH

8 +/- 1

Cleaning tools

With water

Drying

  • 3 h on average, depending on application thickness, temperature, ventilation, humidity and substrate type.

Recommended thicknesses

  • Min. thickness: 0,3 mm
  • Max. thickness: 0,4 mm

CHARACTERISTICS
  • Ease of use for very significantly higher application speed.
  • Excellent adhesive properties (IREF test report no. 08/2-104-L20).
  • Fire rating: A2-s1, d0 as per European standard EN 13501-1.
  • Classification: group III class 2 as per AFNOR NF T 36-005, in compliance with the standard AFNOR NF T 30-608

PACKAGING AND STORAGE
  • 24kg (15L) plastic bucket
  • Shelf life is 9 months in unopened original packaging, protected from frost and extreme heat.

ENVIRONMENTAL INFORMATION
  • VOC content: < 8 g/l.
  • Indoor Air Emission Class

METHOD OF APPLICATION

Substrates:

  • Plasterboard.
  • Finishing on filling plaster.

Preparation of substrate:

  • The substrates, preparatory work and application conditions must be compliant with applicable building trade regulations (e.g. DTU) and standards.

Application tips:

  • The surfaces must be perfectly finished, sanded.
  • Stir before use if necessary.
  • All airless pumps, flow rate > 5 L (do not use filter) for perfect spreading.
  • Airless nozzles size 23 to 27, depending on equipment used (follow the manufacturer’s advice).
  • Recommended pressure 220 bar, 3/8″ tube.
  • Apply a single regular and uniform layer.

Recommendations:

  • Ensure adequate ventilation to remove excess moisture and accelerate drying.

HEALTH AND SAFETY
The safety information sheet is available from: www.icp-alltek.com/en-gb/documentation/