Alltek Y-Max (Tyrex)

Typical Spreadability

2.8 to 6 kg/m² per layer depending on smoothness of substrate.

Density

1,4 +/- 0,1 kg/l

Solid Content

• Solid content by mass: 70%
• Solid content by volume: 58%

Application conditions

• +8°C to +35°C
• Max. relative humidity 70%

pH

8 +/- 1

Cleaning tools

With water

Drying

• 24 to 48 h on average, depending on application thickness, temperature, ventilation, humidity and substrate type. Sanding and recoating: after complete drying.

Recommended thicknesses

• Min. thickness: 2 mm
• Max. thickness: 5 mm

• Ready to use
• Easy to apply.
• Excellent adhesive properties
• Very good spreading power
• Easily sanded
• Fire rating: A2-s1, d0 as per European standard EN 13501-1.
• Classification: group III class 2 as per AFNOR NF T 36-005, in compliance with the standard AFNOR NF T 30-608.

• Returnable, stackable 112 l plastic drum with protective cover.
• Shelf life is 9 months in unopened original packaging, protected from frost and extreme heat.

• VOC content: < 1 g/l.

Substrates:

• Rough concrete (slab floors, precast slabs, formwork, concrete blocks).
• Brick tiles, Monomur bricks, gypsum blocks, plasterboard, plaster.
• Cellular concrete blocks after repair of spalling.

Preparation of substrate:

• The substrates, preparatory work and application conditions must be compliant with applicable building trade regulations (e.g. DTU) and standards.

Application tips:

• Xtreme 60 pump system with 112 l drum (contact us).
• Airless 35 to 41 nozzles, depending on condition of substrate and equipment used (follow the manufacturer’s advice). For a maximum yield, the use of a spray kit is advised.
• If necessary, first treat joints between blocks etc. with Alltek Spray Y-Max.
• Apply an initial smooth layer thick (3mm). After drying, apply a second layer less thickly to obtain a better finish.
• Sand manually or with a machine to achieve a smooth surface ready to paint.
• Sanding with grain size 100 to 150.

Recommendations:

• Ensure adequate ventilation to remove excess moisture and accelerate drying.