ICP Alltek

  1. ICP Alltek
  2. Products
  3. Coatings for manual application
  4. Alltek Roller LM200

Alltek Roller LM200

Manual lightweight filling plaster with roller

DESCRIPTION

Alltek Roller LM200 is a ready-to-use lightweight, light grey plaster that can be applied with a roller.

USE

  • Plaster for interiors, walls and ceilings on all standard substrates.
  • Refurbishment of substrates to obtain smooth surface on glass webs or on stippled surface.
  • With its reliable consistency, Alltek Roller LM200 is very easy to apply with a roller and to smooth.
  • Thick applications possible with a perfect finish obtained more rapidly than with a conventional manually applied plaster.
Typical spreadability 1 litre/m² per mm of thickness.
Recommended thicknesses
  • Min. thickness: 0,5 mm
  • Max. thickness: 4 mm
Packaging 12 litre plastic bucket.

Détails

TECHNICAL SPECIFICATIONS

Typical Spreadability

1 litre/m² per mm of thickness.

Density

1,1 +/- 0,1 kg/l

Solid Content

  • Solid content by mass: 57%
  • Solid content by volume: 48%

Application conditions

  • +8°C to +35°C
  • Max. relative humidity 70%

pH

8 +/- 1

Cleaning tools

With water

Drying

  • 24 h on average, depending on application thickness, temperature, ventilation, humidity and substrate type. Sanding and recoating: after complete drying.

Recommended thicknesses

  • Min. thickness: 0,5 mm
  • Max. thickness: 4 mm

CHARACTERISTICS

  • Ready to use
  • Easily and rapidly applied with roller.
  • Filling plaster with little shrinkage.
  • Easy to use: easily to skim with high quality finish.
  • Mainly used for preparation work.
  • Fire rating: A2-s1, d0 as per European standard EN 13501-1.
  • Classification: group III class 2 as per the standard AFNOR NF T 36-005, in compliance with the standard AFNOR NF T 30-608.

PACKAGING AND STORAGE

  • 12 litre plastic bucket.
  • Shelf life is 1 year in unopened original packaging, protected from frost and extreme heat.

ENVIRONMENTAL INFORMATION

  • VOC content: < 4 g/l.
  •  Indoor Air Emission Class

METHOD OF APPLICATION

Substrates:

  • Concrete, terracotta bricks and tiles, plaster, gypsum blocks, plasterboard.
  • For refurbishment on glass web or textured plaster.
  • Wood and wood products, old painted substrates in good condition

Preparation of substrate:

  • The substrates, preparatory work and application conditions must be compliant with applicable building trade regulations (e.g. DTU) and standards.

Application tips:

  • Immerse a honeycomb or medium dimple or polyamide mesh roller (18 to 24mm) in the coating and apply liberally to the substrate.
  • Then smooth the plaster with a flexible spatula and, if necessary, sand after complete drying with a fine grain sandpaper.

Recommendations:

  • Ensure adequate ventilation to remove excess moisture and accelerate drying.

HEALTH AND SAFETY

The safety information sheet is available from: www.icp-alltek.com/en-gb/documentation/