ICP Alltek

  1. ICP Alltek
  2. Products
  3. Joint fillers
  4. Alltek Joint 2010

Alltek Joint 2010

Enduit à joint Alltek Joint 2010
Date de dernière modification

DESCRIPTION
Alltek Joint 2010 is a ready mixed plaster.

USE
  • Alltekjoint 2010 is a plaster for filling joints between plasterboards with feathered edges.
  • It may also be used for finishing surfaces.
Typical spreadability 0.5 kg/m² of plasterboard wall, i.e. +/- 49 m² for a 25 kg bucket.
Recommended thicknesses
  • Min. thickness: 0,3 mm
  • Max. thickness: 3 mm
Packaging 25 kg plastic bucket.

Détails

TECHNICAL SPECIFICATIONS

Typical Spreadability

0.5 kg/m² of plasterboard wall, i.e. +/- 49 m² for a 25 kg bucket.

Density

1,7 +/- 0,1 kg/l

Solid Content

  • Solid content by mass: 70%
  • Solid content by volume: 49%

Application conditions

  • +5°C to +35°C
  • Max. relative humidity 70%

pH

8 +/- 1

Cleaning tools

With water

Drying

  • 24 h on average, depending on application thickness, temperature, ventilation, humidity and substrate type. Sanding and recoating: after complete drying.

Recommended thicknesses

  • Min. thickness: 0,3 mm
  • Max. thickness: 3 mm

CHARACTERISTICS
  • Ready to use
  • Easy to apply.
  • Outstanding adhesion.
  • Very good spreading power.
  • Excellent adhesion to jointing tape.
  • Easily sanded.
  • Fire rating: A2-s1, d0 as per European standard EN 13501-1.
  • Classification: group III class 2 as per AFNOR NF T 36-005, compliant with the standards AFNOR NF T 30-608 and EN NF 13963.

PACKAGING AND STORAGE
  • 25 kg plastic bucket.
  • Shelf life is 9 months in unopened original packaging, protected from frost and extreme heat.

ENVIRONMENTAL INFORMATION
  • VOC content: < 1 g/l.
  • Indoor Air Emission Class

METHOD OF APPLICATION

Substrates:

  • Plasterboard.

Preparation of substrate:

  • The substrates, preparatory work and application conditions must be compliant with applicable building trade regulations (e.g. DTU) and standards.
  • The plasterboard must be fixed and compliant with DTU 25-41.

Application tips:

  • Stir before use, if necessary.
  • Plaster over any screw heads.
  • Manual or machine application with a high pressure pump, with nozzle sizes 531 to 535.
  • Manual application with Bazooka or supplied by high pressure pump (APLA-TECH system) possible.
  • Manually plaster the feathered plasterboard section with Alltekjoint 2010, then press on the jointing tape with the same plaster. Fill the joint mechanically using a loaded Bazooka and press down the tape with a plastering knife.
  • After drying, skim once or twice manually or mechanically with the finishing attachments.
  • Sanding with grain size 100 to 150

Recommendations:

  • Applying Alltek Sprayplast equalizes differences in absorption between the paper covering of the plasterboard and the plaster. It reduces inequalities and visible surface variables when viewed at oblique angle.

HEALTH AND SAFETY
The safety information sheet is available from: www.icp-alltek.com/en-gb/documentation/