Alltek Roller LM200

Typical Spreadability

1 liter/m² per mm of thickness.

Density

1,1 +/- 0,1 kg/l

Solid Content

• Solid content by mass: 57%
• Solid content by volume: 48%

Application conditions

• +8°C to +35°C
• Max. relative humidity 70%

pH

8 +/- 1

Cleaning tools

With water

Drying

• 24 h on average, depending on application thickness, temperature, ventilation, humidity and substrate type. Sanding and recoating: after complete drying.

Recommended thicknesses

• Min. thickness: 0,5 mm
• Max. thickness: 4 mm

• Ready to use
• Easily and rapidly applied with roller.
• Filling plaster with little shrinkage.
• Easy to use: easily to skim with high quality finish.
• Mainly used for preparation work.
• Fire rating: A2-s1, d0 as per European standard EN 13501-1.
• Classification : group III class 2 as per the standard AFNOR NF T 36-005.
• Product complies with standard NF EN 16566.

• 12 liters plastic bucket (réf. 101675).
• Shelf life is 1 year in unopened original packaging, protected from frost and extreme heat.

• VOC content: < 4 g/l.
• Indoor Air Emission Class

Substrates:

• Concrete, terracotta bricks and tiles, plaster, gypsum blocks, plasterboard.
• For refurbishment on glass web or textured plaster.
• Wood and wood products, old painted substrates in good condition

Preparation of substrate:

• The substrates, preparatory work and application conditions must be compliant with applicable building trade regulations (e.g. DTU) and standards.

Application tips:

• Immerse a honeycomb or medium dimple or polyamide mesh roller (18 to 24mm) in the coating and apply liberally to the substrate.
• Then smooth the plaster with a flexible spatula and, if necessary, sand after complete drying with a fine grain sandpaper.

Recommendations:

• Ensure adequate ventilation to remove excess moisture and accelerate drying.