Alltek Alpha F

Typical Spreadability

1 litre/m² per mm of thickness.

Density

1.7 +/- 0,1 kg/l

Solid Content

• Solid content by mass: 67%
• Solid content by volume: 45%

Application conditions

• +8°C to +35°C
• Max. relative humidity 70%

pH

8 +/- 1

Cleaning tools

With water

Drying

• 12 to 24 h on average, depending on application thickness, temperature, ventilation, humidity and substrate type. Sanding and recoating: after complete drying.

Recommended thicknesses

• Min. thickness: 0,2 mm
• Max. thickness: 1 mm

• Ready to use
• Easy to apply.
• Ergonomic and rapid application, minimum retouching
• Excellent adhesive properties
• Very good spreading power
• Easily sanded
• Fire rating: A2-s1, d0 as per European standard EN 13501-1.
• Classification: group III class 2 as per AFNOR NF T 36-005, in compliance with the standard AFNOR NF T 30-608.

• 15L plastic bucket
• Shelf life is 9 months in unopened original packaging, protected from frost and extreme heat.

• VOC content: < 1 g/l.
• Indoor Air Emission Class

Substrates:

• Wallboard and plasterboard after filling of joints, sprayed plaster.
• As finish on concrete.
• Wood and wood products, old painted substrates in good condition.

Preparation of substrate:

• The substrates, preparatory work and application conditions must be compliant with applicable building trade regulations (e.g. DTU) and standards.

Application tips:

• Stir before use if necessary.
• All airless pumps, flow rate > 5 L (do not use filter).
• Airless 25 to 31 nozzles, depending on condition of substrate and equipment used (follow the manufacturer’s advice).
• Flexible smoothing knife of “Parfaitliss” type or similar.
• Sanding with grain size 180 to 220.

Recommendations:

• Ensure adequate ventilation to remove excess moisture and accelerate drying.